Power UNITS FOR LIFT TABLE one
Standard Description
This power unit is intended exclusively for that compact lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit continues to be widely applied in the sector of logistic units for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled from the solenoid valve with all the velocity controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This energy unit is built solely to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as the speed controlled by the adjustable needle valve. Once the lift rises to a high positoin, however the power supply is reduce, the lowering motion is controlled through the guide override function.
Power UNITS FOR LIFT TABLE three
General Description
This power unit is made solely for the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as pace controlled by a stress compensated flow control valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This power unit is made solely for the huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the pace managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is minimize, the reducing motion is managed by the guide override perform.
Exclusive Notes
one. This electrical power unit is of S3 duty cycle, which could only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic components concerned prior to set up of the electrical power unit.
three. Viscosity on the oil shoud be 15~46 cst,which should also be clean and free of charge of impurities.N46 hydraulic oil is suggested.
four. Oil modifying is needed just after the first one hundred operation hrs,afterwards the moment each and every 3000 hrs.
5. The power unit proven is built to be mounted vertically.